This weekend I was in State Championship / World Cup in Cape Verde Canyon, MG, organized by the athlete and professor Augustine Melo. There I had opportunity to examine and observe the use of bench shirts varied, but predominantly the brand Cannon.
Although I already knew the brand, not had even seen a large variety of models and copies, produced at different times. The brand has a few years and can be Engand, but it seems to me that the most significant technological innovations were introduced in the last two or three.
is important in making this relationshipp distinguish between "model" and "exemplary." The model refers to the type of material, type of collar, open, number of layers and other structural features. However, as different from other brands of bench shirt, cutting, fitting and sleeve measures are fully customized. There are two "T-Rex" identical, for example.
To clarify, I make a comparison with the famous and great shirts Titan. I sort the shirts Titan, all the models tested, as follows: firstly in terms of "permissiveness motion" comes the Fury of a cloth, described by the manufacturer as good for any style but more suited to the bench without arc ( "flatbencher). Then we have the F6 (of which there are several sub-models), which is most appropriate for the athlete who runs a curved bench, while still allowing a wider range of angles of the articulations ; s elbow and shoulder, as well as fitting and point of contact with the athlete's body. Finally, we have Katanas - A / S for bench presses and bent S / S bench presses without a bow. The Katanas, whose material is more consistent, has a different cut, with a twist seam on the triceps, which practically "force" the movement of the athlete. Another description would be that she so strongly favors a particular movement and any other damages both the athlete can not make large or no benefit from the equipment. Therefore, Titan has "models" rather than "exemplary." Although the athlete order a shirt tailored, his measurements will be within the general cut of the shirt you choose.
Manufacturing Cannon not work that way. All shirts are ordered and tailored, but not models exist in the sense described above. The same model can be made for an athlete footprint open or closed, fit high or low, or movement with emphasis on the triceps deltoid ripple eccentric / concentric with the joint elbow "outside-in" or "inside-out." Anyway: the pattern is determined by the mechanical movement of each particular athlete. Thus, a flatbencher and an arched supinator can both use a shirt T-Rex model. However, the mold used for each vary.
not know how it is done - I am not a manufacturer of equipment, but the athlete and student surveys. As such, I formed a very positive opinion of shirts manufacturing Cannon, who compete well with those imported. The use of multiple layers, also made by foreign manufacturers, in the case of shirts Cannon is, in some models, a mechanism to generate a specific type of resistance. As incredible as it may seem to someone who not handled these materials, an area of multiple-layer trelissada may offer less resistance and more elasticity than a single layer of NXG (tissue Titan's patented).
We can see how this national manufacturer uses creative with the material available and possible to create the effect of mechanical proteçãoe carry-over which the athlete supine needs .
The biggest news is a new shirt of two layers of new material, good strength and light. I was told by the owner and creator of the shirt, Roger Cannon, the company prepares to launch more innovations in the equipment market powerlifting.
look forward with great anticipation.
[Note: I am no athlete patrocindada Cannon brand, used shirts from all brands and in this particular event used an Inzer shirt brand]
More information:
http://www.canhaobenchpress.c
Marilia Coutinho, Ph.D.
CREF 059869-P/SP
Curriculum Sports:
http://www.athletebio .com/bra1963f1
http://www.bodystuff.org/curriculoesportivo.html
0 comments:
Post a Comment